The medals accumulate whether you plan for them or not

Twenty years of parkruns, club handicaps and the local half every autumn adds up quietly. Nobody sets out to collect them; they end up in a drawer, in a bag, on the back of a chair, and one day there are sixty.

This is the men's cut of the design. If the drawer is already deep, start at 60 cm — a display bought for a collection that has been accumulating for two decades is almost always bought too small.

Two decades of parkrun and club races is a bigger pile than anyone remembers. It is worth actually emptying the drawer before ordering.

The same medal display is cut in several widths. Buying as a gift? Count what is already in the drawer and go one size up.

Size & capacity

Not sure which size?

For a collection built over fifteen years or more, start at 60 cm and consider 75.

Made from one sheet, not assembled from parts

The medal holder is laser-cut from a single piece of AISI 304 stainless steel, 2.5-3 mm thick depending on the width. Nothing welded on, nothing to come loose.

Medals hang on a continuous rail rather than individual hooks, so you're limited by the width of the bar and nothing else.

Mounting

Everything is in the box: stainless standoffs, screws, wall plugs and a paper template. Mark through the template, drill, done — about ten minutes.

After the first one is full

They're made to pair. A second unit sits flush against the first and the run reads as a single display. The widest version holds up to 110 medals across three rails.

When it arrives

Each medal hanger is made to order in the EU and leaves within 3–5 working days. Fourteen days to change your mind once it is in your hands.